Got a Minor Question

[Sweldon]

I made a few model and placed them into A2 but only 1/2 of the ship shows up until you zoom into it then next 1/2 appears and first half disappears ? How do I fix ?

 

[SquireJames]

Sounds like some form of texture or mesh lodding (i.e, one texture is loaded as lod 0 and another as lod 1, so when zoomed out half the ship is missing as it has no texture at that lod level, reverse holding true for the other lod).

Make sure you don't have any textures with _1 or _2 after them being applied, and make sure your model is DEVOID of lods, as you don't need them with modern hardware.

 

[Sweldon]

Sounds like some form of texture or mesh lodding (i.e, one texture is loaded as lod 0 and another as lod 1, so when zoomed out half the ship is missing as it has no texture at that lod level, reverse holding true for the other lod).

Make sure you don't have any textures with _1 or _2 after them being applied, and make sure your model is DEVOID of lods, as you don't need them with modern hardware.

ok then I should get rid of lod1 and lod2 then there would be no model how exactly should i get rid of lod 0 ? I have no lod_1 or lod_2 any where ..
ship screen shot inputed as attachment..

 

[SquireJames]

Did I say to get rid of lod 0? No, lod 0 is the main lod, the one you want to keep. When I said make sure its devoid of lods, I meant the secondary and tertiary lods that are sometimes present in a model. Could you post a screenshot of the ship with the skeleton turned off?

 

[Sweldon]

It is possibly not the best ship but I think I did good. here image attached without wireframe and joints